SCPI Command Tree
See Also
Stops all sweeps |
+ CALCulate Click to hide and show CALC branches
Electrical Delay and Phase Offset |
|
Sends and queries data. |
|
Equation Editor |
|
Time domain gating |
|
Display format |
|
Balanced measurements and Fixturing |
|
Trace Statistics |
|
Trace Hold |
|
Limit lines for pass / fail testing |
|
Marker settings |
|
Math / Memory |
|
X-axis display for FCA measurements |
|
Receiver power cal (Obsolete) |
|
Mag and Phase offset |
|
Create and delete measurements |
|
Queries receiver data |
|
Point-to-point smoothing |
|
Time domain transform |
|
X-Axis Domain |
Controls CalPod units |
|
Interface control, ECal module state control, and Rear-panel connector control. |
|
Work with a Cal Set without having to select it into that channel. |
|
Display settings |
|
Format for data transfer |
|
Hardcopy printing |
|
Continuous or manual triggering |
|
LXI communications |
|
Saves and recalls instrument states |
|
Turns RF power ON and OFF |
+ SENSe Click to hide and show SENSe branches
Sweep Averaging |
|
IF Bandwidth |
|
Calibration and other correction settings |
|
| CKIT |
Manage Cal Kits and ECal modules |
Edit Cal Kit definitions |
|
Perform Guided Cals |
|
| CSET |
Manage Cal Sets |
Port Extensions |
|
Chopped or Alternate sweep |
|
Frequency sweep settings |
|
Returns the source of the reference oscillator |
|
Segment sweep settings |
|
Sweep types |
|
Returns the temperature on the receiver board |
|
Returns X-axis values for channel |
Source power to the DUT |
|
Source power calibration |
|
Reads the PNA status registers |
|
Misc PNA capabilities |
|
| CAL:All |
Calibrate All Channels |
PXI module capabilities |
|
Controls and queries PNA settings |
|
Shared memory commands |
|
VNA Preferences |
|
Instrument Cal dates |
|
Trigger measurements |