Configure Restore Settings

Infineon Security Platform

Infineon Security Platform Solution - Backup Wizard

Configure Restore Settings

With this page you can specify the Backup Archive to be restored from. If you have administrative rights, you can also specify a restoration reason.

Availability of page: This page is not available in server mode as Backup and Restoration is handled by Trusted Computing Management Server, i.e. no explicit configuration is necessary.

The following table gives hints on how to use this wizard page.

Wizard Page Element

Explanation

Broken hard disk or lost data
New Trusted Platform Module
New Security Platform to be initialized

Depending on the Security Platform state one of the following restoration reasons is selected:

Broken hard disk or lost data: The Security Platform does have an owner.
This state typically occurs, if the Security Platform Solution is initialized and ready to use, but some user data is not accessible any more.
New Trusted Platform Module: The Security Platform does not have an owner, but old Security Platform settings or credentials are existing.
This state typically occurs, if the Security Platform Solution Software had been installed before, and then the Trusted Platform Module was either replaced or reset in the BIOS.
New Security Platform to be initialized: The Security Platform does not have an owner. No old Security Platform settings or credentials could be found.
This state typically occurs, if you are going to perform the restoration on a PC, on which the Security Platform Solution Software has not been installed before.

Note, that you cannot change this selection.

The restoration reason is only displayed for users with administrative rights.

Specify the path and filename of the Backup Archive to restore
Browse...

You need to specify the Backup Archive to be restored from.
Type in path and file name or browse for it.

The backup file is a file in XML format.

previous page start next page