2. Create the Task

LabView NI-DAQmx Measurement

2. Create the Task

In the Create New Express Task dialog box of the DAQ Assistant, complete the following steps to create a task to measure voltage from the DAQ device.

  1. Select Acquire Signals.
  2. Select Analog Input for the I/O type.
  3. Select Voltage for the measurement to perform.
  4. In Supported Physical Channels, select the physical channel on the DAQ device to which you connected the voltage signal.
  5. Click Finish.

The DAQ Assistant task configuration screen launches.

Previous: 1. Launch the DAQ Assistant Next: 3. Configure the Task