3. Configure the Task
After you create a task, you can configure channel-specific settings such as custom scaling, input range, and terminal configuration. You also can configure task-specific settings such as timing and triggering.
To configure the voltage measurement task, complete the following steps.
- Specify the input range. You can use the default values.
- Select the terminal configuration you used to connect the signal.
- Under Timing Settings, select N Samples as the Acquisition Mode. Enter 100.00 for Samples To Read, and enter 1000.00 for Rate (Hz), as shown in the following figure.
![]() |
Note This example does not use custom scaling or triggering. To learn about scaling and triggering, refer to the NI-DAQmx Help. |
Previous: 2. Create the Task | Next: 4. Test the Task |