Before You Begin
To use this tutorial, you must have the following software and hardware installed in your system:
- LabVIEW 8.x or later
- NI-DAQmx from NI-DAQ 8.x or later, including LabVIEW 7.x or later support files
- A data acquisition (DAQ) device, physical or simulated, that is supported by NI-DAQmx and is connected to a voltage signal. Refer to the Measurement & Automation Explorer Help for NI-DAQmx for instructions on creating an NI-DAQmx simulated device. Refer to the NI-DAQ Readme file to see if NI-DAQmx supports your device.
Refer to the DAQ Getting Started Guide and the device documentation for information about installing and configuring the software and hardware.
| Previous: Introduction to Taking an NI-DAQmx Measurement in LabVIEW | Next: Channels and Tasks in NI-DAQmx |