Settings for 'Save output as dxf' option

You can assign the default setting whether the Save output as dxf checkbox option should remain checked or unchecked when the 'Create Nesting Job' dialog is displayed for a new nesting job. This particular setting is available in the DefaultValues.ini file.

Editing the settings for the 'Save output as dxf' checkbox option in DefaultValues.ini

1. Open the file named DefaultValues.ini located in the CAMWorksNesting Installation folder.
2. Observe the section named [NestingData].  
3. The  setting for enabling/disabling the option for saving the nested layout output in a '.dxf' file format is given in the last two lines under the [NestingData] section.
4. The flag named 'DxfFile' indicates whether the 'Save output as dxf' checkbox option will be checked or unchecked.
5. When the 'DxfFile' flag is set to '1', the 'Save output as dxf' checkbox will remain checked when the 'Create Nesting Job' dialog is displayed for a new nesting job. This is the default setting at the time of installation.

[NestingData]

...

...

;Option for creating DXF file : 1 : Yes, 0 : No

DxfFile =1

6. When the 'DxfFile' flag is set to '0', the 'Save output as dxf' checkbox will remain unchecked when the Create Nesting Job dialog is displayed for a new nesting job.

[NestingData]

...

...

;Option for creating DXF file : 1 : Yes, 0 : No

DxfFile =0