Defining Sheet Length and Width

Use the Sheet Data tab of the Create Nesting Job dialog to add sheet(s) and set the parameters for sheet(s) in which parts will be nested.

The sheet Length and Width dimensions are mandatory sheet parameters for nesting (except for sheets of DXF format).

 

Length and Width of Standard Size Sheets:

The length and width for standard sized sheets are defined in the StandardSheets-INCH.ini and StandardSheets-MM.ini file.  Consequently, if you choose a standard size sheet in the Sheet data tab, the pre-defined length and width dimensions of the sheet will be used for nesting. You cannot edit the length and width of a Standard sheet in the Sheet Data tab.

To change the length and width for a Standard sheet present in the Sheet list, remove the sheet from the sheet list and add another sheet with desired length and width.

The Length and Width fields are disabled for Standard Size sheets.

 

Length and Width for Custom Size sheets:

Custom Size sheets are non-standard rectangular sheets. If you choose a Custom Size sheet, the Length and Width fields in the Sheet Data tab are activated. Enter the desired length and width values in this fields before adding the sheet to the Sheet List.

Once a Custom Size sheet is added to the Sheet List, you can edit its Length and Width within the Sheet List. Alternatively, you can use the Length and Width fields given below the Sheet list grid to change its values.

To change the Unit system used in the Create Nesting Job dialog, change the Unit system in SolidWorks settings.

The Length and Width can be entered in MMGS or IPS unit system (all of these are supported by SolidWorks).

To view the steps to insert a Custom Size Sheet, click here.

 

Length and Width for Sheet DXF:

If you choose 'Sheet DXF' type of sheet, the length and width parameters will not be applicable. The perimeter of such a sheet can only be edited only in the CAD software in which it is designed. You cannot edit the length and width of a Sheet DXF in the Sheet Data tab.

The Length and Width fields are disabled for Sheet DXF sheets.