NIRFSG_ATTR_UPCONVERTER_LOOP_BANDWIDTH
Specific Attribute
| Data type |
Access | Applies to | Coercion | High Level Functions |
|---|---|---|---|---|
| ViInt32 | R/W | N/A | None | None |
Description
Configures the loop bandwidth of the upconverter tuning PLLs. To set this attribute, the NI-RFSG device must be in the Configuration state.
 |
Note This property is ignored for signal bandwidths greater than or equal to 10 MHz. |
Defined Values:
| NIRFSG_VAL_LOW | Specifies that the upconverter module uses a low loop bandwidth. |
| NIRFSG_VAL_MEDIUM | Specifies that the upconverter module uses a medium loop bandwidth. |
| NIRFSG_VAL_HIGH | Specifies that the upconverter module uses a high loop bandwidth. |
Default Value: NIRFSG_VAL_HIGH
Supported Devices: NI 5610 (upconverter only mode), NI 5670/5671/5672