niDMM_ConfigureMeasCompleteSlope

From NI-DMM C/CVI/VB

previous page next page

niDMM_ConfigureMeasCompleteSlope

ViStatus = niDMM_ConfigureMeasCompleteSlope(ViSession Instrument_Handle, ViInt32 Meas_Complete_Slope)

Purpose

Sets the Measurement Complete signal to either rising edge (positive) or falling edge (negative) polarity.

Parameters

Input

Name Type Description

Instrument_Handle ViSession Identifies a particular instrument session. You obtain the Instrument_Handle parameter from niDMM_init or niDMM_InitWithOptions. The default is None.

Meas_Complete_Slope

ViInt32

Specifies the polarity of the signal that is generated. The driver sets NIDMM_ATTR_MEAS_DEST_SLOPE to this value.

Rising Edge	0	NIDMM_VAL_POSITIVE	The driver triggers on the rising edge of the trigger signal.
Falling Edge (default)	1	NIDMM_VAL_NEGATIVE	The driver triggers on the falling edge of the trigger signal.

Return Value

Name	Type	Description
Status	ViStatus	Reports the Status of this operation. To obtain a text description of the status code, call niDMM_error_message. To obtain additional information concerning the error condition, use niDMM_GetError.

previous page start next page