To calibrate a plotter (Procedure)

Calibrate Plotters and Work with Custom Paper Sizes

Up a level to ..

Calibrate Plotters and Work with Custom Paper Sizes

 

Use Plotters and Printers > Control PC3 File Device and Document Settings > Calibrate Plotters and Work with Custom Paper Sizes > 

Calibrate Plotters and Work with Custom Paper Sizes

Concept

Procedure

Quick Reference

To calibrate a plotter

1. From the File menu, choose Plotter Manager.
2. Double-click the Add-a-Plotter wizard icon.
3. Start the Add-a-Plotter wizard and configure the device you want to add.
4. When you reach the Add Plotter - Finish page, choose Calibrate Plotter.

   You can also calibrate a plotter by running the Plotter Configuration Editor on an existing PC3 file for the device you want to calibrate.

5. In the Paper Size list, select a paper size for the test plot. Choose Next.
6. On the Calibrate Plotter - Rectangle Size page, in the Units list, select the measurement units.
7. In the Length and Width boxes, enter the dimensions of the test rectangle. Choose Next. AutoCAD plots the test rectangle.
8. Retrieve the plot and measure the test rectangle. On the Calibrate Plotter - Measured Plot page, in the Measured Length and Measured Width boxes, enter the actual dimensions of the plotted test rectangle. Choose Next.

   AutoCAD compares the actual plotted measurements to the size you specified in the preceding screen and computes the correction needed to accurately calibrate the plotter.

9. On the Calibrate Plotter - File name page, enter a file name. Choose Next.

   The resulting PMP file is stored in the AutoCAD Drv folder.

10. On the Calibrate Plotter - Finish page, choose Check Calibration.

    AutoCAD plots the text rectangle again. Measure the sides again to verify that the calibration is correct.

11. Choose Finish to return to the Add-a-Plotter wizard or Plotter Configuration Editor.

 Command entry: PLOTTERMANAGER