Use AutoSpool
Port Settings
Configure Serial Ports
|
|
|
|
|
|
|
|
|
Some plotters support a timeout value, which specifies how much time elapses while the plotter empties its buffer before more data is sent to the plotter.
After the plotter empties its buffer, it accepts more data from AutoCAD. Enter the amount of time you want to elapse before AutoCAD prompts you to abort the plot. If your drawings are complex or your pen speed is very slow, set the timeout value higher than the default (30 seconds). If you begin to receive numerous timeout messages, your timeout setting is probably too low. For plotters that support a timeout value, you can also set the timeout value by choosing Configure Port on the Ports page during the initial configuration in the Add-a-Plotter wizard.