Replacing a Network Module with a Network Module of a Different Type
To replace a network module on a FieldPoint bank and keep the same configuration for all of the I/O modules on the bank, complete the following steps:
- Turn off the power to the bank and disconnect the power supply from the network module.
- Remove the network module from the bank.
- Install the new network module as described in the quick start guide shipped with the module.
- Connect the power supply to the new network module as described in the quick start guide.
- Connect the new network module to the computer or the network.
- Power up the network module.
- Find the comm resource for the configured bank under My System»Devices and Interfaces, right-click it, and select Go to Comm Resource Configuration.
- Click the + sign beside the comm resource so that the bank icon appears, right-click the bank icon, and select Copy Bank.
- Click Next.
- Select the comm resource type for the new network module. Select Ethernet for an Ethernet network module or RS232/485 for a serial network module.