documentation.HELP! NI-SCOPE Express VI Control Documentation

NI-SCOPE Express VI Help

NI-SCOPE Express VI Control

Table of contents

  • NI-SCOPE Express VI Control Help
    • NI-SCOPE Express
    • Acquire
    • Autoscale graph
    • Auto Setup
    • Bandwidth (Hz)
    • Coupling
    • Channels
    • Enable TIS
    • Input impedance
    • Offset (V)
    • Probe attenuation
    • Range (V)
    • Coupling
    • DC restore
    • Delay (s)
    • Device
    • Event
    • Enable TIS
    • High level (V)
    • Holdoff (s)
    • Hysteresis (V)
    • Level (V)
    • Level (V)
    • Line number
    • Low level (V)
    • Max time (s)
    • Output:
    • Per Div Mode
    • Polarity
    • Post-execution delay (ms)
    • Pre-execution delay (ms)
    • Range (V/Div)
    • Record length
    • Read length
    • Reference clock source
    • Ref position (%)
    • RIS enabled
    • Sample rate (S/s)
    • Signal format
    • Slope
    • Source
    • Source
    • Source
    • Start this step after
    • Step to wait for
    • Output:
    • Time/Division
    • Use relative initial time
    • Type
    • Wait on Previous
    • Wait Type
    • Acquired Signals
    • Window mode
next page

Menu

  • Homepage

Table of contents

  • NI-SCOPE Express VI Control Help
    • NI-SCOPE Express
    • Acquire
    • Autoscale graph
    • Auto Setup
    • Bandwidth (Hz)
    • Coupling
    • Channels
    • Enable TIS
    • Input impedance
    • Offset (V)
    • Probe attenuation
    • Range (V)
    • Coupling
    • DC restore
    • Delay (s)
    • Device
    • Event
    • Enable TIS
    • High level (V)
    • Holdoff (s)
    • Hysteresis (V)
    • Level (V)
    • Level (V)
    • Line number
    • Low level (V)
    • Max time (s)
    • Output:
    • Per Div Mode
    • Polarity
    • Post-execution delay (ms)
    • Pre-execution delay (ms)
    • Range (V/Div)
    • Record length
    • Read length
    • Reference clock source
    • Ref position (%)
    • RIS enabled
    • Sample rate (S/s)
    • Signal format
    • Slope
    • Source
    • Source
    • Source
    • Start this step after
    • Step to wait for
    • Output:
    • Time/Division
    • Use relative initial time
    • Type
    • Wait on Previous
    • Wait Type
    • Acquired Signals
    • Window mode

Get in touch

Submit feedback about this site to:

  • [email protected]

© documentation.help. Design: rehmann.co.