documentation
.HELP!
NI-SCOPE Express VI Control Documentation
Max time (s)
NI-SCOPE Express VI Control
previous page
next page
Max time (s)
Specifies the hardware timeout value in seconds.
previous page
start
next page
Menu
Homepage
Table of contents
NI-SCOPE Express VI Control Help
NI-SCOPE Express
Acquire
Autoscale graph
Auto Setup
Bandwidth (Hz)
Coupling
Channels
Enable TIS
Input impedance
Offset (V)
Probe attenuation
Range (V)
Coupling
DC restore
Delay (s)
Device
Event
Enable TIS
High level (V)
Holdoff (s)
Hysteresis (V)
Level (V)
Level (V)
Line number
Low level (V)
Max time (s)
Output:
Per Div Mode
Polarity
Post-execution delay (ms)
Pre-execution delay (ms)
Range (V/Div)
Record length
Read length
Reference clock source
Ref position (%)
RIS enabled
Sample rate (S/s)
Signal format
Slope
Source
Source
Source
Start this step after
Step to wait for
Output:
Time/Division
Use relative initial time
Type
Wait on Previous
Wait Type
Acquired Signals
Window mode
Get in touch
Submit feedback about this site to:
[email protected]