Light:Set State Method
Short Name: Light.Set State
Installed With: Full Development System
Class: SceneObject Methods
Sets a state for the light.
Parameters
| Name | Required | Description | ||||||
|---|---|---|---|---|---|---|---|---|
| Light State | No | Specifies whether to enable the state of the light.
| ||||||
| Light Number | No | The number that identifies the light. The default is 0. |
Remarks
The following table lists the characteristics of this method.
| Available in Run-Time Engine and Real-Time Operating System | Yes (Read/Write) |
| Settable when the VI is running | Yes |
| Loads the front panel into memory | No |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access disallowed | No |
| Must wait until user interface is idle | No |
| Available with control VIs | No |
| Available with global VIs | No |
| Available with strict type definitions | No |
| Available with polymorphic VIs | No |