Object:Add Object Method
Short Name: Object.Add Object
Installed With: Full Development System
Class: SceneObject Methods
Reads or writes a 3D object you add to a 3D scene. If you wire the Object output, you must close the reference when you no longer need it.
Parameters
| Name | Required | Description |
|---|---|---|
| Object | No | The refnum input for the object you add to the 3D scene. |
| Object | No | The refnum output for the object you add to the 3D scene. |
Remarks
The following table lists the characteristics of this method.
| Available in Run-Time Engine and Real-Time Operating System | Yes (Read/Write) |
| Settable when the VI is running | Yes |
| Loads the front panel into memory | No |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access disallowed | No |
| Must wait until user interface is idle | No |
| Available with control VIs | No |
| Available with global VIs | No |
| Available with strict type definitions | No |
| Available with polymorphic VIs | No |