Managing Connection Views
When a remote capture session is established DebugView creates a new computer view for the session. The active computer view is the one that has captured output displayed in the DebugView GUI, and is identified on the DebugView title bar. To switch from one computer view to another select the desired view, which is listed by computer name, in the Computer menu. Alternatively, you can use Ctrl+Tab to cycle through the computer views.
The state of global capture, Win32 debug capture, kernel capture, and pass-through for a newly established remote session are all adopted from the current settings of the local view (the view of the computer on which the DebugView is executing). Changes you make to these settings only apply to the active computer view.
Disconnecting a Remote Session
When you are through capturing debug output from a remote system, make the view for the computer from which you want to disconnect the active view and then use the Computer|Disconnect menu entry to close the session.
When you exit DebugView it saves the state of the local view, including the width of the display columns, and DebugView applies those settings the next time you start it.