CALCulate:AVERage:MINimum?

34980A

CALCulate:AVERage:MINimum?

Syntax

CALCulate:AVERage:MINimum? [(@<ch_list>)]

Description

This command returns the minimum value found on each of the specified channels during the scan. Each channel must be a channel that has been configured to be part of the scan list. If you omit the optional <ch_list> parameter, this command applies to the internal DMM, independent of any channels or a scan list.

Used With:

  • 34921A through 34925A Multiplexer Modules

  • 34950A Digital I/O Module (digital input and counter channels only)

  • 34952A Multifunction Module (digital input and totalizer channels only)

Parameters

Name

Type

Range of Values

Default Value

<ch_list>

Numeric

One or more channels in the form (@sccc).

If <ch_list> is omitted, this command applies to the internal DMM.

Remarks

  • You can read the values at any time, even during a scan. An error is generated if the internal DMM is disabled (see INSTrument:DMM[:STATe] command) or not installed in the mainframe.

  • If you omit the optional <ch_list> parameter, this command returns the minimum reading taken by the internal DMM, independent of any channels or a scan list. The calculation starts when the internal DMM is triggered.

  • The instrument clears the stored statistical data on all channels when a new scan is started, when the CALCulate:AVERage:CLEar command is executed, after a Factory Reset (*RST command), or after an Instrument Preset (SYSTem:PRESet command).

Return Format

The command returns one value for each channel specified. Multiple responses are separated by commas. If no data is available for the specified channels, "0" is returned.

Example

The following query returns the minimum values found on channels 1 and 3 in slot 1.

CALC:AVER:MIN? (@1001,1003)

Typical Response:  +4.27150000E-03,+1.32130000E-03

See Also

CALCulate:AVERage:CLEar

CALCulate:AVERage:MINimum:TIME?