STM32F0xx Standard Peripherals Firmware Library: Programmable Voltage Detector (PVD) example

  ******************** (C) COPYRIGHT 2014 STMicroelectronics *******************
  * @file    SYSCFG/SYSCFG_PVD/readme.txt 
  * @author  MCD Application Team
  * @version V1.4.0
  * @date    24-July-2014
  * @brief   Description of the Programmable Voltage Detector (PVD) example.
  ******************************************************************************
  *
  * Licensed under MCD-ST Liberty SW License Agreement V2, (the "License");
  * You may not use this file except in compliance with the License.
  * You may obtain a copy of the License at:
  *
  *        http://www.st.com/software_license_agreement_liberty_v2
  *
  * Unless required by applicable law or agreed to in writing, software 
  * distributed under the License is distributed on an "AS IS" BASIS, 
  * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
  * See the License for the specific language governing permissions and
  * limitations under the License.
  *
  ******************************************************************************
   

Example Description

This example shows how to configure the programmable voltage detector.

In this example:

• TIM1 is configured to generate a PWM signal on pin PA.08.
• PVD threshold is configured to level 5.

While Vdd is higher than the PVD threshold (~2.68 V), PWM signal is displayed on PA.08. While Vdd is lower than the PVD threshold (~2.58 V), PA8 is in low level.

Note:

Refer to the electrical characteristics of your device datasheet for more details about the voltage threshold corresponding to each PVD detection level.

Directory contents

• SYSCFG/PVD/stm32f0xx_conf.h Library Configuration file
• SYSCFG/PVD/stm32f0xx_it.c Interrupt handlers
• SYSCFG/PVD/stm32f0xx_it.h Interrupt handlers header file
• SYSCFG/PVD/main.c Main program
• SYSCFG/PVD/main.h Header for main.c module
• SYSCFG/PVD/system_stm32f0xx.c STM32F0xx system source file

Note:

The "system_stm32f0xx.c" is generated by an automatic clock configuration tool and can be easily customized to meet user application requirements. To select different clock setup, use the "STM32F0xx_Clock_Configuration_VX.Y.Z.xls" provided with the AN4055 package available on ST Microcontrollers

Hardware and Software environment

• This example runs on STM32F0xx devices.

• This example has been tested with STMicroelectronics STM320518-EVAL and STM32072B-EVAL including respectively STM32F051R8T6 and STM32F072VBT6 devices and can be easily tailored to any other supported device and development board

• STM320518-EVAL Set-up
  • Use RV2 Potentiometer to adjust Vdd.
  • Make sure that jumper JP9 is in position(VDD_ADJ).
  • Connect an oscilloscope to PA.08 pin to display the waveform.

• STM32072B-EVAL Set-up
  • Use RV2 Potentiometer to adjust Vdd.
  • Make sure that jumper JP13 is in position(VDD_ADJ).
  • Connect an oscilloscope to PA.08 pin to display the waveform.

How to use it ?

In order to make the program work, you must do the following :

• Copy all source files from this example folder to the template folder under Project
• Open your preferred toolchain
• Rebuild all files and load your image into target memory
• Run the example

© COPYRIGHT STMicroelectronics