Real-Time:UseBuffering Property
Short Name: RT.UseBuffering
Installed With: Base Package
Class: Variable Properties
If TRUE, LabVIEW uses the configuration you specify in the Use Buffering section of the Network page of the Shared Variable Properties dialog box to configure the size and elements of a real-time first-in-first-out (FIFO) buffer for a shared variable. The default is FALSE. To use this property, you must install the LabVIEW Real-Time Module.
 | Note If you are using a network-published Shared Variable node that is configured to read data, you must run each Shared Variable node before the node subscribes and starts receiving buffered values. |
Remarks
The following table lists the characteristics of this property.
| Available in Run-Time Engine and Real-Time Operating System | No |
| Permissions | Read/Write |
| Settable when the VI is running | Yes |
| Loads the front panel into memory | No |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access disallowed | No |
| Must wait until user interface is idle | No |
| Available with control VIs | No |
| Available with global VIs | No |
| Available with strict type definitions | No |
| Available with polymorphic VIs | No |