C Code Generation:Generate Serial Only Property
Short Name: CCodeGen.SerialOnly
Installed With: Embedded Targets, Mobile Module, Touch Panel Module
Class: VI Properties
Generates C code without cooperative multitasking code. Removing this cooperative multitasking code makes the C code easier to read and usually runs much faster. However, you lose parallel execution behavior. This execution behavior most closely resembles subroutine priority VIs in LabVIEW for Windows.
This property is similar to the Generate serial only option on the C Code Generation Options page of the VI Properties dialog box.
Remarks
The following table lists the characteristics of this property.
| Available in Run-Time Engine and Real-Time Operating System | Yes |
| Permissions | Read/Write |
| Settable when the VI is running | Yes |
| Loads the front panel into memory | No |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access disallowed | No |
| Must wait until user interface is idle | No |
| Available with control VIs | No |
| Available with global VIs | No |
| Available with strict type definitions | No |
| Available with polymorphic VIs | No |