Wrap Distance Property
Short Name: WrapDistance
Installed With: Full Development System
Class: SceneText Properties
Specifies how much of the text in a text object LabVIEW renders in one line. If you use the Vertical? property to render the text vertically, this property sets the maximum height of the text object. If you render the text horizontally, this property sets the maximum width of the text object. If the length of the text exceeds the wrap distance, LabVIEW wraps the text to a new line. If you set this property to 0, LabVIEW does not wrap the text.
 | Note You cannot use this property to truncate text. If you want to cut off the text, use the Clip Plane:Add Clip Plane to clip the text object. |
Remarks
The following table lists the characteristics of this property.
| Available in Run-Time Engine and Real-Time Operating System | Yes |
| Permissions | Read/Write |
| Settable when the VI is running | Yes |
| Loads the front panel into memory | No |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access disallowed | No |
| Must wait until user interface is idle | No |
| Available with control VIs | No |
| Available with global VIs | No |
| Available with strict type definitions | No |
| Available with polymorphic VIs | No |