Radius Property

LabView Local Project Settings

Radius Property

Short Name: Radius

Installed With: Full Development System

Class: SceneSphere Properties

Reads or writes the radius of the sphere. The default is 0.

Remarks

The following table lists the characteristics of this property.

Available in Run-Time Engine and Real-Time Operating SystemYes
PermissionsWrite In Edit Only
Settable when the VI is runningYes
Loads the front panel into memoryNo
Need to authenticate before useNo
Loads the block diagram into memoryNo
Remote access disallowedNo
Must wait until user interface is idleNo
Available with control VIsNo
Available with global VIsNo
Available with strict type definitionsNo
Available with polymorphic VIsNo