Data Binding:Path Property
Short Name: BindingPath
Installed With: Base Package
Class: Control Properties
Reads or writes the NI Publish-Subscribe-Protocol URL to which the control is connected. To write this property, you must bind the control to the PSP URL before you begin writing.
 | Note If the control is bound to a project item instead of a PSP URL and you attempt to write this property, this property returns an error. |
To bind the control to a PSP URL, use the Bind to Network Path method while the VI is not running.
Remarks
The following table lists the characteristics of this property.
| Available in Run-Time Engine and Real-Time Operating System | Yes |
| Permissions | Read/Write |
| Settable when the VI is running | Yes |
| Loads the front panel into memory | No |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access disallowed | No |
| Must wait until user interface is idle | No |
| Available with control VIs | No |
| Available with global VIs | No |
| Available with strict type definitions | Yes |
| Available with polymorphic VIs | No |