Standard Function Output:Start Phase

Short Name: Start Phase

This property controls horizontal offset of the standard waveform the signal generator will produce. You specify this property in degrees of one waveform cycle.

A start phase of 180 degrees means output generation begins halfway through the waveform. A start phase of 360 degrees offsets the output by an entire waveform cycle, which is identical to a start phase of 0 degrees.

Default Value: None

Units: Degrees of one cycle

Note  This parameter does not affect signal generator behavior when you set the Waveform property to NIFGEN_VAL_WFM_DC.

Remarks

The following table lists the characteristics of this property.

Data Type	ViReal64
Permissions	R/W
Channel Based	Yes
High-Level VI	niFgen Configure Standard Waveform VI niFgen Configure Frequency List VI