Scaling and Conversion (Time Domain)

LabVIEW SignalExpress

previous page next page

Scaling and Conversion (Time Domain)

Performs gain and offset scaling on a time signal, gain scaling on a frequency-domain magnitude signal, or time-delay correction on a frequency-domain phase signal.

ParameterDescription
Input SignalDisplays the input time signal to be scaled.
  • Displayed signal—Specifies the signal(s) to display in the preview graph(s). This option appears only when you select a group of signals for the input.
    Note  If the input signals include scalar values that depend on the values of input waveform signals, you cannot specify to display all signals in the preview graph(s).
Scaled SignalDisplays the scaled time signal.
InputContains the following option:
  • Input signal—Specifies the analog waveform for the step.
ConfigurationContains the following option:
  • Operation Setup—Contains the following options:
    • Pre-gain offset—Specifies the amount of offset to add to the signal before gain. The default is 0.
    • Gain—Specifies the multiplication factor to apply to the time signal. The default is 1.
    • Post-gain offset—Specifies the amount of offset to add to the signal after gain. The default is 0.
    • Equivalent diagram—Displays the LabVIEW equivalent block diagram of the scaling operation you select.
previous page start next page