ConnectorFormat Object

Multiple objectsConnectorFormat Shape

Contains properties and methods that apply to connectors. A connector is a line that attaches two other shapes at points called connection sites. If you rearrange shapes that are connected, the geometry of the connector will be automatically adjusted so that the shapes remain connected.

Using the ConnectorFormat Object

Use the ConnectorFormat property to return a ConnectorFormat object. Use the BeginConnect and EndConnect methods to attach the ends of the connector to other shapes in the document. Use the RerouteConnections method to automatically find the shortest path between the two shapes connected by the connector. Use the Connector property to see whether a shape is a connector.

Note that you assign a size and a position when you add a connector to the Shapes collection, but the size and position are automatically adjusted when you attach the beginning and end of the connector to other shapes in the collection. Therefore, if you intend to attach a connector to other shapes, the initial size and position you specify are irrelevant. Likewise, you specify which connection sites on a shape to attach the connector to when you attach the connector, but using the RerouteConnections method after the connector is attached may change which connection sites the connector attaches to, making your original choice of connection sites irrelevant.

The following example adds two rectangles to myDocument and connects them with a curved connector.

Set myDocument = Worksheets(1)
Set s = myDocument.Shapes
Set firstRect = s.AddShape(msoShapeRectangle, 100, 50, 200, 100)
Set secondRect = s.AddShape(msoShapeRectangle, 300, 300, 200, 100)
Setc c = s.AddConnector(msoConnectorCurve, 0, 0, 0, 0)
With c.ConnectorFormat
    .BeginConnect ConnectedShape:=firstRect, ConnectionSite:=1
    .EndConnect ConnectedShape:=secondRect, ConnectionSite:=1
    c.RerouteConnections
End With
		

Remarks

Connection sites are generally numbered according to the rules presented in the following table.

To figure out which number corresponds to which connection site on a complex shape, you can experiment with the shape while the macro recorder is turned on and then examine the recorded code; or you can create a shape, select it, and then run the following example. This code will number each connection site and attach a connector to it.

Set mainshape = ActiveWindow.Selection.ShapeRange(1)
With mainshape
    bx = .Left + .Width + 50
    by = .Top + .Height + 50
End With
With ActiveSheet
    For j = 1 To mainshape.ConnectionSiteCount
        With .Shapes.AddConnector(msoConnectorStraight, _
                bx, by, bx + 50, by + 50)
            .ConnectorFormat.EndConnect mainshape, j
            .ConnectorFormat.Type = msoConnectorElbow
            .Line.ForeColor.RGB = RGB(255, 0, 0)
            l = .Left
            t = .Top
        End With
        With .Shapes.AddTextbox(msoTextOrientationHorizontal, _
                l, t, 36, 14)
            .Fill.Visible = False
            .Line.Visible = False
            .TextFrame.Characters.Text = j
        End With
    Next j
End With