PIC32 on Explorer 16 Demo Board for MiWi™ PRO
Explorer 16 Demo board use PIC32MX360F512L MCU as the host controller. Select "Configure" from the MPLAB menu and then choose "Select Device...". From the pop up menu, choose "PIC32MX360F512L" as the device and then click "OK".
Open either the simple example or feature demo project for PIC32.
From the project window, choose to edit file "ConfigApp.h" under the directory "Header Files -> Application", as shown below.
In file "ConfigApp.h", first elect to use MiWi PRO protocol, make sure to uncomment "#define PROTOCOL_MIWI_PRO" and comment out "#define PROTOCOL_P2P" and "#define PROTOCOL_MIWI".
Second step, choose the RF transceiver to be used. Three RF transceivers: MRF24J40, MRF49XA and MRF89XA are supported in this release. Support of RF transceiver is enabled by uncomment one and only one following defintions:
#define MRF24J40
#define MRF49XA
#define MRF89XA
From the project window, choose to edit file "HardwareProfile.h" under the directory "Header Files -> Application", as shown below
In the file "HardwareProfile.h", choose the Explorer 16 board by uncomment "#define EXPLORER16" and comment out all other demo boards definitions.
Compile the project and then load the hex file to the MCU through a programmer or debugger.