CONFigure Subsystem Introduction
CONFigure Subsystem Introduction
The CONFigure commands provide the most flexible way to program the instrument for measurements. When you execute these commands, the instrument uses default values for the requested measurement configuration (like the MEASure? command). However, the measurement is not automatically started and you can change some measurement attributes before actually initiating the measurement. This allows you to incrementally change the instrument's configuration from the default conditions.
|
|
Use the INITiate or READ? command to initiate the measurement. A MEASure command is simply a CONFigure command followed by a READ? If you specify a <ch_list> with one of these commands, that <ch_list> overwrites the current scan list. |
The CONFigure commands are valid only with the following Keysight 34970A/34972A plug-in modules which can be configured to be part of a scan. If the internal DMM is not installed or is disabled, then no DMM-related configurations are allowed. However, scanning is allowed on the digital input and totalizer channels even without the internal DMM.
34901A 20-Channel Armature Multiplexer (2-wire or 4-wire) 34902A 16-Channel Reed Multiplexer (2-wire or 4-wire) 34907A Multifunction Module (digital input and totalizer channels only) 34908A 40-Channel Armature Multiplexer (2-wire only)