CALibration:VALue
CALibration:VALue
Syntax
CALibration:VALue <value>
CALibration:VALue?
Description
This command specifies the value of the known calibration signal as outlined in the calibration procedures in the Keysight 34970A/34972A Service Guide. This command is used for internal DMM calibrations.
For a more detailed discussion of the calibration procedures, see the Keysight 34970A/34972A Service Guide. Please refer to that guide before attempting to calibrate the instrument as improper use of the CALibration commands can adversely affect the accuracy and reliability of the instrument.
Parameters
Name Type Range of Values Default Value <value> Numeric
Desired calibration signal in the units specified by the present measurement function. This is a required parameter.
Remarks
- The internal DMM is an optional assembly for the Keysight 34970A/34972A. The instrument generates an error with this command if the internal DMM is disabled (see INSTrument:DMM command) or not installed in the mainframe.
Return Format
The query returns the calibration value in the form +1.00000000E-01.
Examples
The following command sets calibration value to +10.001010 volts.
CAL:VAL 10.001010
The following query returns the present calibration value.
CAL:VAL?
Typical Response: +1.00101000E+01
See Also
CALibration Subsystem Introduction