CALCulate Subsystem Introduction

CALCulate Subsystem Introduction

The internal DMM is required to store readings in memory and perform calculations. Readings can be acquired during a scan using the 34970A/34972A multiplexer modules listed below.

 

34901A   20 Channel Multiplexer (2/4-wire) Module

34902A   16 Channel Multiplexer (2/4-wire) Module

34907A   Multifunction Module

34908A   40 Channel Single-Ended Multiplexer Module

Command Summary

CALCulate:AVERage:AVERage?

CALCulate:AVERage:CLEar

CALCulate:AVERage:COUNt?

CALCulate:AVERage:MAXimum?

CALCulate:AVERage:MAXimum:TIME?

CALCulate:AVERage:MINimum?

CALCulate:AVERage:MINimum:TIME?

CALCulate:AVERage:PTPeak?

 

CALCulate:COMPare:DATA

CALCulate:COMPare:DATA?

CALCulate:COMPare:MASK

CALCulate:COMPare:MASK?

CALCulate:COMPare:STATe

CALCulate:COMPare:STATe?

CALCulate:COMPare:TYPE

CALCulate:COMPare:TYPE?

 

CALCulate:LIMit:LOWer

CALCulate:LIMit:LOWer?

CALCulate:LIMit:LOWer:STATe

CALCulate:LIMit:LOWer:STATe?

CALCulate:LIMit:UPPer

CALCulate:LIMit:UPPer?

CALCulate:LIMit:UPPer:STATe

CALCulate:LIMit:UPPer:STATe?

 

CALCulate:SCALe:GAIN 

CALCulate:SCALe:GAIN?

CALCulate:SCALe:OFFSet

CALCulate:SCALe:OFFSet?

CALCulate:SCALe:OFFSet:NULL

CALCulate:SCALe:STATe

CALCulate:SCALe:STATe?

CALCulate:SCALe:UNIT  

CALCulate:SCALe:UNIT?