SYSTem:CPON

SYSTem:CPON

Syntax | Description | Parameters | Remarks | Return Format | Example

Syntax

SYSTem:CPON <slot>

Description

This command resets the module in the specified slot to its power-on state (CPON means "card power on"). See Factory Reset State for a complete listing of the instrument's Factory configuration.

Parameters 

Name	Type	Range of Values	Default Value
<slot>	Discrete	{100|200|300|ALL}	This is a required parameter.

Remarks

• The various module cards are affected as follows:
  
  

Module	Effect
34901A	If any channel is configured for a measurement, this command has no effect. If no channel is configured, this command opens all channels.
34902A	If any channel is configured for a measurement, this command has no effect. If no channel is configured, this command opens all channels.
34903A	This command opens all channels.
34904A	This command opens all channels.
34905A	This command closes channels 11 and 21.
34906A	This command closes channels 11 and 21.
34907A	This command resets all channels not involved in scan to the power-on state.
34908A	If any channel is configured for a measurement, this command has no effect. If no channel is configured, this command opens all channels.

• This command does not reset the internal DMM.
• The instrument will produce an error if you are actively scanning and try to execute a SYSTem:CPON for a card that is involved in the scan.
• To reset the modules in all three slots in the instrument, use the ALL keyword shown above.

Example

The following command resets the module in slot 200.

SYST:CPON 200

See Also

SYSTem Subsystem Introduction

SYSTem:PRESet

*RST