Save User Specified Format Output
This menu will allow the user to output specifically selected data types for the current run. These selections are automatically saved to the current probe run. The defaults for this dialog may be specified in the PROBEWIN.INI file in the [software] section. See Configuration Files section for more information.
The data types that may be saved are:
SAMPLE Sample name (in double quotes)
NUMBER Sample number
TO Analytical conditions (Takeoff)
KEV Analytical conditions (Kilovolts)
NA Analytical conditions (Beam current in nA)
UM Analytical conditions (Beam size in microns)
LINE Line number
El WT% Elemental weight percent
El (O2) Oxide weight percent
El AT% Atomic weight percent (elemental mole percent)
El OXMOL% Oxide mole percents
TOTAL Total weight percent
FORMULA Formula basis element (or none for sum of cations)
BASIS Formula basis element number (or total cations)
El FORMULA Formula basis calculation based on FORMULA and BASIS
MINERAL Mineral end member basis (olivine, feldspar, etc)
END-MEMBER1 Value for end member 1
END-MEMBER2 Value for end member 2
END-MEMBER3 Value for end member 3
END-MEMBER4 Value for end member 4
El CDL99 Detection limit in elemental weight percent at 99% confidence
El %ERR Analytical error in relative percent (one sigma)
X-POS X stage position
Y-POS Y stage position
Z-POS Z stage position
RELDIST Relative distance (in microns)
BEAMCURR Beam or probe current (in nA) (array if combined conditions sample)
ABSCURR Absorbed current (in nA) (array if combined conditions sample)
BEAMCURR2 Beam or probe current (in nA) (array if combined conditions sample)
ABSCURR2 Absorbed current (in nA) (array if combined conditions sample)
El ONTIM On-peak counting time(includes x-ray line, spectro number and crystal)
El HITIM High off-peak counting time (x-ray, spectro and crystal)
El LOTIM Low off-peak counting time (x-ray, spectro and crystal)
El ONCNT Raw On-peak count intensity (cps/nominal beam) (x-ray, spectro and crystal)
El OFCNT Calculated Off-peak count intensity (cps/nominal beam) (x-ray, spectro and crystal)
El NECNT Net (off-peak, interference, etc. corrected) count intensity (cps/nominal beam) (x-ray, spectro and crystal)
El KRAT Elemental k-ratio (normalized to pure element) (x-ray, spectro and crystal)
DATE-TIME Acquisition date and time (Excel format)
Z-COR Atomic number correction factor
A-COR Absorption correction factor
F-COR Fluorescence correction factor
ZAF Z*A*F correction factor
MAC Elemental Mass Absorption Coefficient
El K-RAW Elemental raw k-ratio (unk counts/standard counts)
STD_NUM Primary standard assignment number
STD_NAM Primary standard assignment name
TOTAL-WT% Total weight percent
TOTAL-OXYGEN Total oxygen (excess plus calculated)
TOTAL-CATIONS Total cations
OXYGEN(Calc) The calculated oxygen (from stoichiometry)
OXYGEN(Excess) The excess oxygen (specified or measured)
Z-BAR The average atomic number (weight fraction normalized)
AVG ATWT The average atomic weight
OXYGEN(Halogen Equiv.) The oxygen equivalent of all halogens
OXYGEN(Halogen Corr.) The halogen corrected stoichiometric oxygen
CHARGE The calculated total charge balance for all cations and anions
FE-CHARGE The averge calculated charge balance for Fe
INTF% Interference correction percent (relative)
MANABSCOR% MAN continuum absorption correction percent (relative)
APF Area peak factor corrections (1.0 = none)
TDI_COR% Time dependent intensity correction percents (relative)
TDI_DEV% Time dependent intensity correction fit average deviation