Trigger:Measurement Complete Dest Property
Short Name: Measurement CompletDest
Property of niDMM
Specifies the destination of the measurement complete (MC) signal.
 |
Note The NI 4050 is not supported. |
To determine which values are supported by each device, refer to the LabVIEW Trigger Routing section in the NI Digital Multimeters Help.
| None (-1) |
No destination specified. |
| External (2) |
Pin 6 on the AUX Connector |
| TTL 0 (111) |
PXI Trigger Line 0 |
| TTL 1 (112) |
PXI Trigger Line 1 |
| TL 2 (113) |
PXI Trigger Line 2 |
| TTL 3 (114) |
PXI Trigger Line 3 |
| TL 4 (115) |
PXI Trigger Line 4 |
| TTL 5 (116) |
PXI Trigger Line 5 |
| TTL 6 (117) |
PXI Trigger Line 6 |
| TTL 7 (118) |
PXI Trigger Line 7 |
| LBR Trig 0 (1003) |
Local Bus Right Trigger Line 0 of PXI/SCXI combination chassis |
Remarks
The following table lists the characteristics of this property.
| Datatype |  |
| Permissions | Read/Write |
| High-level VIs | niDMM Configure Meas Complete Dest |
| Resettable | No |