Digital output
Digital outputs are designated with an “Q”. The output connects a digital signal through from its input to its output. In FluidSIM digital components can be used inside and outside a digital module.
If a digital output is used inside a digital module, you can determine the output connector of the digital module in question with which the digital output shall be linked by allocating a number “Q1” to “Q16”. If the status of the digital output is “Hi”, a potential of 24V is set at the corresponding output connector of the digital module.
If a digital output is used outside a digital module, there is an additional analog electrical connection at the digital output. If the status of the digital output is “Hi”, a potential of 24 V is set a this connection.
Related Topics