SI Set Sampling Rate to System Model VI
Owning Palette: Model Management VIs
Installed With: System Identification Toolkit
Applies a sampling rate to a system model. Use the SI Get Sampling Rate from System Model VI to retrieve the sampling rate from a system model.
 Place on the block diagram | Find on the Functions palette |
 | system model contains information about the model structure, nominal or estimated parameters, identification result, and so on. | ||||||
 | sampling rate specifies the sampling rate to apply to system model. If system model is a continuous system, set sampling rate to a value less than or equal to 0. | ||||||
 | error in describes error conditions that occur before this VI or function runs.
The default is no error. If an error occurred before this VI or function runs, the VI or function passes the error in value to error out. This VI or function runs normally only if no error occurred before this VI or function runs. If an error occurs while this VI or function runs, it runs normally and sets its own error status in error out. Use the Simple Error Handler or General Error Handler VIs to display the description of the error code. Use error in and error out to check errors and to specify execution order by wiring error out from one node to error in of the next node.
| ||||||
 | system model out returns information about the model structure, nominal or estimated parameters, identification result, and so on. | ||||||
 | error out contains error information. If error in indicates that an error occurred before this VI or function ran, error out contains the same error information. Otherwise, it describes the error status that this VI or function produces.
Right-click the error out front panel indicator and select Explain Error from the shortcut menu for more information about the error.
|
