Clear All Faults VI
Owning Palette: Faults VIs
Installed With: RT Module
Clears all active faults on the target.
 Place on the block diagram | Find on the Functions palette |
 | target address specifies the IP address or DNS name of the target. | ||||||
 | error in describes error conditions that occur before this VI or function runs.
The default is no error. If an error occurred before this VI or function runs, the VI or function passes the error in value to error out. This VI or function runs normally only if no error occurred before this VI or function runs. If an error occurs while this VI or function runs, it runs normally and sets its own error status in error out. Use the Simple Error Handler or General Error Handler VIs to display the description of the error code.
Use exception control to treat what is normally an error as no error or to treat a warning as an error.
Use error in and error out to check errors and to specify execution order by wiring error out from one node to error in of the next node.
| ||||||
 | error out contains error information. If error in indicates that an error occurred before this VI or function ran, error out contains the same error information. Otherwise, it describes the error status that this VI or function produces.
Right-click the error out front panel indicator and select Explain Error from the shortcut menu for more information about the error.
|
Clear All Faults Details
This VI does not allocate memory, so you can use this VI in a time-critical section of an application without significantly affecting determinism.
This VI applies only to targets with the NI Scan Engine installed. You must either run this VI on a target with the NI Scan Engine installed or use the target address input to point to a target with the NI Scan Engine installed.
Example
Refer to the Scan Engine.lvproj in the labview\examples\scanengine directory for an example of using the Clear All Faults VI.
Open example Browse related examples