Adding or Removing Software
You can install the LabVIEW Real-Time Module or other driver software on the remote target after you have assigned it an IP address.
If your RT target has LabVIEW Real-Time preinstalled, you may still need to download additional driver software. In this case, the state of your RT target should be Connected-Running on the Network Settings tab.
If your RT target has a Windows operating system installed, you must install LabVIEW Real-Time. You can install or upgrade LabVIEW Real-Time or other driver software using the LabVIEW Real-Time Software Wizard.
Complete the following steps to launch the LabVIEW Real-Time Software Wizard:
- Expand Remote Systems in the configuration tree and then expand your RT target.
- Select the Software category. Click the Add/Remove Software icon on the toolbar to launch the LabVIEW Real-Time Software Wizard. If your RT target does not have a Software category, it does not support the LabVIEW Real-Time software.
- Use the LabVIEW Real-Time Software Wizard to add, remove, or update the software on your remote target.