Update Deadband:User Property
Short Name: UpdateDeadband.User
Installed With: Base Package
Class: Variable Properties
Gets or sets the deadband for updating the value of a shared variable when a user writes data to the variable. To use this property, you must install the LabVIEW Datalogging and Supervisory Control Module.
This property is similar to the User Deadband (% of range) option on the Update Deadband page of the Shared Variable Properties dialog box.
Remarks
The following table lists the characteristics of this property.
| Available in Run-Time Engine and Real-Time Operating System | No |
| Permissions | Read/Write |
| Settable when the VI is running | Yes |
| Loads the front panel into memory | No |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access disallowed | No |
| Must wait until user interface is idle | No |
| Available with control VIs | No |
| Available with global VIs | No |
| Available with strict type definitions | No |
| Available with polymorphic VIs | No |