Custom Item Symbols:Revert To Built In Symbol Method
Short Name: Custom Item Symbols.Revert Symbol
Installed With: Full Development System
Class: TreeControl Methods
Resets an item symbol to the default symbol for its index.
Parameters
| Name | Required | Description |
|---|---|---|
| Index | No | The index of the symbol you want to set. The default is 0. You also can wire a listbox symbol ring constant to this parameter to select the custom item symbol you want to replace with a default item symbol. |
Remarks
The following table lists the characteristics of this method.
| Available in Run-Time Engine and Real-Time Operating System | Yes (Read/Write) |
| Settable when the VI is running | Yes |
| Loads the front panel into memory | No |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access disallowed | No |
| Must wait until user interface is idle | No |
| Available with control VIs | No |
| Available with global VIs | No |
| Available with strict type definitions | No |
| Available with polymorphic VIs | No |