Horizontal Wrap Mode Property
Short Name: HorizontalWrapMode
Installed With: Full Development System
Class: SceneTexture Properties
Read or writes how the texture is wrapped horizontally around a 3D object.
Values
| 0 | Clamp—Applies the texture image to the object with texture coordinates clamped to the range [0…1]. LabVIEW interprets any texture coordinates outside this range with clamped values. The texture does not repeat across the surface of the object. |
| 1 | Repeat—The texture repeats across the surface of the object when you pass texture coordinates outside the range [0…1]. LabVIEW only considers the fractional part of the texture coordinate. For example, LabVIEW interprets 0.4 and 3.4 as the same texture coordinate. |
Remarks
The following table lists the characteristics of this property.
| Available in Run-Time Engine and Real-Time Operating System | Yes |
| Permissions | Write In Edit Only |
| Settable when the VI is running | Yes |
| Loads the front panel into memory | No |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access disallowed | No |
| Must wait until user interface is idle | No |
| Available with control VIs | No |
| Available with global VIs | No |
| Available with strict type definitions | No |
| Available with polymorphic VIs | No |