Line Width Property
Short Name: LineWidth
Installed With: Base Package
Class: Cursor Properties
Specifies the width of the line used to display the active cursor. Valid values are 0–4, as shown on the shortcut menu of the plot legend and on the Cursors page of the Properties dialog box ordered from top to bottom.
Assigning a value of 0 results in a line width of exactly one pixel. Assigning values 1–4 will result in a line width of increasing thickness based upon the resolution of the monitor.
This property is similar to the Line Width item of the shortcut menu of the cursor legend of a graph and the Line width option on the Cursors page of the Properties dialog box.
Remarks
The following table lists the characteristics of this property.
| Available in Run-Time Engine and Real-Time Operating System | Yes |
| Permissions | Read/Write |
| Settable when the VI is running | Yes |
| Loads the front panel into memory | No |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access disallowed | No |
| Must wait until user interface is idle | No |
| Available with control VIs | No |
| Available with global VIs | No |
| Available with strict type definitions | No |
| Available with polymorphic VIs | No |