Specifies the powerline frequency.

Configures the DMM for auto zero. When Auto Zero is ON, the DMM internally disconnects the input and takes a zero reading. It then subtracts the zero reading from the measurement. This prevents offset voltages present on the input circuitry of the DMM from affecting measurement accuracy. When Auto Zero is OFF, the DMM does not compensate for zero reading offset.

(NI 4070/4071/4072 only) Allows the DMM to compensate for gain drift since the last external or self-calibration. When ADC Calibration is ON, the DMM measures an internal reference to calculate the correct gain for the measurement. When ADC Calibration is OFF, the DMM does not compensate for changes to the gain.

(NI 4070/4071/4072 only) Allows the DMM to compensate for voltage offsets in resistance measurements. When Offset Compensated Ohms is enabled, the DMM measures the resistance twice (once with the current source on and again with it turned off). Any voltage offset present in both measurements is cancelled out. Offset Compensated Ohms is useful when measuring resistance values less than 10 kOhms.

Configures the Min Frequency and Max Frequency properties that the DMM uses for AC measurements.

(NI 4070/4071/4072 only) Specifies the expected maximum amplitude of the input signal for frequency and period measurements.

Configures the current source for diode measurements. The NI 4050 and NI 4060 are not supported.

(NI 4070/4071/4072 only) Configures instrument coupling for voltage waveforms.

Use the NI-DMM Capacitance and Inductance VIs for control of the inductance and capacitance capabilities on the NI 4072.

Use the NI-DMM Temperature VIs to configure for temperature measurements.