DAQmx Self Calibrate
Measures the onboard reference voltage of the device and adjusts the self calibration constants to account for any errors caused by short-term fluctuations in the operating environment. When you self calibrate a device, no external signal connections are necessary.
For 42xx devices, this VI performs a self-calibration on the 4200 baseboard, then performs an offset-only calibration on the full signal path of the device.
Place on the block diagram. |
Find on the Functions palette. |
 |
device in is the name as configured in MAX of the device to which this operation applies. A DAQmx device name constant lists all devices installed in the system. | ||||||
 |
error in describes error conditions that occur before this VI or function runs. The default is no error. If an error occurred before this VI or function runs, the VI or function passes the error in value to error out. If an error occurs while this VI or function runs, the VI or function runs normally and sets its own error status in error out. Use the Simple Error Handler or General Error Handler VIs to display the description of the error code. Use error in and error out to check errors and to specify execution order by wiring error out from one node to error in of the next node.
|
||||||
 |
error out contains error information. If error in indicates that an error occurred before this VI or function ran, error out contains the same error information. Otherwise, error out describes the error status that this VI or function produces. Right-click the error out indicator on the front panel and select Explain Error from the shortcut menu for more information about the error.
|
