expression.ScaleTop
expression Required. An expression that returns one of the objects in the Applies To list.
Remarks
You can set the ScaleTop property by using a macro or a Visual Basic event procedure specified by a section's OnPrint property setting.
By using these properties and the related ScaleHeight and ScaleWidth properties, you can set up a custom coordinate system with both positive and negative coordinates. All four of these Scale properties interact with the ScaleMode property in the following ways:
- Setting any other Scale property to any value automatically sets the ScaleMode property to 0.
- Setting the ScaleMode property to a number greater than 0 changes the ScaleHeight and ScaleWidth property settings to the new unit of measurement and sets the ScaleLeft and ScaleTop properties to 0. Also, the CurrentX and CurrentY property settings change to reflect the new coordinates of the current point.
You can also use the Scale method to set the ScaleHeight, ScaleWidth, ScaleLeft, and ScaleTop properties in one statement.
Note The ScaleTop property isn't the same as the Top property.
Example
The following example uses the Circle method to draw a circle and create a pie slice within the circle. Then it uses the FillColor and FillStyle properties to color the pie slice red. It also draws a line from the upper left to the center of the circle.
To try this example in Microsoft Access, create a new report. Set the OnPrint property of the Detail section to [Event Procedure]. Enter the following code in the report's module, then switch to Print Preview.
Private Sub Detail_Print(Cancel As Integer, PrintCount As Integer)
Const conPI = 3.14159265359
Dim sngHCtr As Single
Dim sngVCtr As Single
Dim sngRadius As Single
Dim sngStart As Single
Dim sngEnd As Single
sngHCtr = Me.ScaleWidth / 2 ' Horizontal center.
sngVCtr = Me.ScaleHeight / 2 ' Vertical center.
sngRadius = Me.ScaleHeight / 3 ' Circle radius.
Me.Circle (sngHCtr, sngVCtr), sngRadius ' Draw circle.
sngStart = -0.00000001 ' Start of pie slice.
sngEnd = -2 * conPI / 3 ' End of pie slice.
Me.FillColor = RGB(255, 0, 0) ' Color pie slice red.
Me.FillStyle = 0 ' Fill pie slice.
' Draw Pie slice within circle
Me.Circle (sngHCtr, sngVCtr), sngRadius, , sngStart, sngEnd
' Draw line to center of circle.
Dim intColor As Integer
Dim sngTop As Single, sngLeft As Single
Dim sngWidth As Single, sngHeight As Single
Me.ScaleMode = 3 ' Set scale to pixels.
sngTop = Me.ScaleTop ' Top inside edge.
sngLeft = Me.ScaleLeft ' Left inside edge.
sngWidth = Me.ScaleWidth / 2 ' Width inside edge.
sngHeight = Me.ScaleHeight / 2 ' Height inside edge.
intColor = RGB(255, 0, 0) ' Make color red.
' Draw line.
Me.Line (sngTop, sngLeft)-(sngWidth, sngHeight), intColor
End Sub