Requery Method

Updates the data in a Recordset object by re-executing the query on which the object is based.

Syntax

recordset.Requery Options

Parameter

Options

Optional. A bitmask that contains ExecuteOptionEnum and CommandTypeEnum values affecting this operation.

Note   If Options is set to adAsyncExecute, this operation will execute asynchronously and a RecordsetChangeComplete event will be issued when it concludes.

The ExecuteOpenEnum values of adExecuteNoRecords or adExecuteStream should not be used with Requery.

Remarks

Use the Requery method to refresh the entire contents of a Recordset object from the data source by reissuing the original command and retrieving the data a second time. Calling this method is equivalent to calling the Close and Open methods in succession. If you are editing the current record or adding a new record, an error occurs.

While the Recordset object is open, the properties that define the nature of the cursor (CursorType, LockType, MaxRecords, and so forth) are read-only. Thus, the Requery method can only refresh the current cursor. To change any of the cursor properties and view the results, you must use the Close method so that the properties become read/write again. You can then change the property settings and call the Open method to reopen the cursor.

See Also

Visual Basic Example | VBScript Example | Visual C++ Example | Visual J++ Example

CommandText Property

Applies To: Recordset Object