IviDCPwr Simulator Setup Dialog Box

Two sets of properties exist for use with the IviDCPwr Simulation Driver. You use the dialog box shown below to configure the measurement simulation for the IviDCPwr Simulator driver. Scroll down to see a description of each control.

Simulator Setup Dialog Box

Always prompt for output data simulation

Leaving this control selected causes the panel to appear at every measurement acquisition event in your program. All simulated acquisitions in the program use the same measurement configuration information. Unselecting this control causes the measurement simulation panel to never appear again during the course of your program.

Channel

This control specifies the channel for which you want to configure a simulation measurement.

Measurement

Enter the measurement base to use for all computer generated measurements. All computer generated measurement values fall within the range of this value plus or minus the value of the Noise control. Valid Range: any value

Noise

Enter the reading noise to use for all computer generated measurements. All computer generated measurement values fall within the range of the value of the Measurement control plus or minus this value. Valid Range: any positive value