ROUTe:CLOSe:EXCLusive
ROUTe:CLOSe:EXCLusive
Syntax
ROUTe:CLOSe:EXCLusive (@<ch_list>)
Description
This command opens all channels on a multiplexer or switch module and then closes the specified channels. On the multiplexer modules, if any channel on the module is defined to be part of the scan list, attempting to send this command will result in an error.
Used With:
- All modules except 34907A
Parameters
Name Type Range of Values Default Value <ch_list> Channel List One or more channels, as shown:
(@310) - channel 10 on the module in slot 300.
(@305:310) - channels 05 through 10 on the module in slot 300.
(@202:207,209,302:308) - channels 02 through 07 and 09 on the module in slot 200 and channels 02 through 08 on the module in slot 300.
This is a required parameter.
Remarks
- For the matrix modules (34904A), the channel number represents the intersection of the desired row and column. For example, channel 234 represents the intersection of row 3 and column 4 on the module in slot 200 (assumes two-wire mode). For more information, see the simplified schematics.
- This command opens all channels first, and then closes the channels in the <ch_list>, one at a time. Before it closes each channel, it opens all previous channels.
- The RF Multiplexer modules (34905A, 34906A) will not respond to the ROUTe:OPEN command (an error is generated). To "open" a channel on these modules, send the ROUTe:CLOSe:EXCLusive command to a different channel in the same bank.
Example
The following command opens all channels and then closes channel 03 on the matrix module in slot 300.
ROUT:CLOS:EXCL (@303)
See Also