DIAGnostic:DMM:CYCLes:CLEar

DIAGnostic:DMM:CYCLes:CLEar

Syntax | Description | Parameters | Remarks | Return Format | Example

Syntax

DIAGnostic:DMM:CYCLes:CLEar {1|2|3}

Description

This command resets the relay cycle count on the specified internal DMM relay.

Remarks

• You must unsecure the instrument with CALibration:SECure:STATe to reset the cycle count.

Example

The following command resets the relay cycle count on internal DMM relay 2.

DIAGnostic:DMM:CYCLes:CLEar 2

See Also

DIAGnostic Subsystem Introduction

DIAGnostic:DMM:CYCLes?