Parameters
You may set parameters for this particular measurement. Measurement parameters can be used during a measurement, for the input of extra values (that is, additionally to the primary measurement result) that influence the final result.
Enter the parameter code exactly like it will be used in the calculation formulas of the final result. Also, enter a short description and a default value. Check the ‘Measurement on drawing’ option in case you wish the value of this particular parameter to be defined by marking a length on the drawing during the measurement.
You can redefine the marking length of a
parameter, at any time, by moving its end points. All relevant measurement
values will be adjusted accordingly.
The parameter values can be different per
sub-measurement (See Drawings/Measurement
analysis). In the Measurement analysis window, the parameter
values used in each sub-measurement appear in a separate column.
The parameter codes can include numbers, but
they must not start with a number. Also, the characters R, L, A, and P1, P2 …Pn
are not valid (they are used by the program to symbolize results and general
parameters).
Use the navigator at the bottom of the
window to move from one entry to another or to delete an entry. Specifically,
use the 
, 
buttons to move to the previous or next
entry, the
,
to move to the previous or next page, the 
, 
buttons to move to the first or last entry,
and, finally, the 
button to
delete an entry.